- BeniaK, J., Šooš, L., Matúš, M., Križan, P., Bednárik, M. THE EFFECT OF TOPOLOGICAL OPTIMIZATION ON THE STRENGTH PROPERTIES OF PARTS MANUFACTURED BY ADDITIVE MANUFACTURING.
- Cada, R., Tiller, P., Hikade, A. BLANK MATERIAL INFLUENCE IN STAMPING SPRINGBACK.
- Jurga, T., Mrkvica, I., Slaninkova, A. COMPUTER SUPPORT FOR THE DESIGN OF THE HOB CUTTER.
- Krizan, P., Pokusova, M., Matus, M., Strigac, S., Babics, J. RESEARCH INTO POSSIBILITIES OF CHROMIUM CAST IRON MACHINING USING EDM WIRE TECHNOLOGY.
- Mechali, A., Mesicek, J., Ma Quoc, P., Hajnys, J., Gautam, P., Krisak, D., Petru, J. ABRASIVE SURFACE TREATMENT OF ALSI10MG PARTS MADE BY L-PBF.
- Ochodek, V., Szymura, M. PROPERTIES OF GRADIENT LAYERS OBTAINED THROUGH HVOF SPRAYING AND PLASMA CLADDING.
- Posmyková E., Hruban, J., Měsíček, J., Bláha, R., Ma Quoc, P., Hajnyš, J., Petrů, J. DESIGN OF A FRAME OF INLINE SKATES MADE BY ADDITIVE TECHNOLOGY.
- Stepien, K., Kmiecik-Sołtysiak, U., Cepova, L. THE STUDY OF THE PROBLEM OF SCANNING SPEED ON RESULTS OF MEASUREMENTS OF FORM DEVIATIONS.
- Sternadelova, K., Krupova, H., Hajnys, J., Mesicek, J., Mohyla, P. INFLUENCE OF SURFACE PRETREATMENT ON THE QUALITY OF THE VITREOUS ENAMEL COATING.
- Tavodova, M., Krilek, J., Falat, L. ASSESSMENT OF THE SUITABILITY OF APPLYING AlCrN COATING TO A CHOPPING KNIFE.
- Kamenszka, A., Vaclav, S., Mares, A. THE USE OF DATABASES IN THE PLANNING OF ASSEMBLY WORKPLACES AND SYSTEMS.
Plné verze článků budou vydány v časopise MM Science Journal po úspěšném recenzním řízení.
https://www.mmscience.eu/en/about-us
