Labs

Mechanical Test Laboratory (E109): Equipped with hydraulic test presses ZD 10 and ZD 40 with numerical control for tensile, compression, and bending tests. There is a STE-13-HR-So heater for mechanical testing...

Volume Forming Laboratory (F108): A hydraulic press DP2000 (2 MN) with manual or TestEmotion control; a heating mantle for induction heating of forming tools, controlled by a dTRON 304 unit with NiCr-Ni...

Surface Forming Laboratory (F109): Here, a semi-automatic hydraulic press CBJ 100-11 and a hydraulic shop press CDC 10-8 are located here, where pressing, bending, straightening, shearing, drawing, stretching...

Laboratory of Electrochemistry and Electroforming (HB211): The laboratory has technologies for electrodeposition of nickel and copper coatings. There is a Picomat experimental electroplating line...

Technological Process Modelling Laboratory (D303): The computers here are installed with AutoCAD, SolidWorks, Simufact.Forming, Simufact.Welding, FORMFEM, PAM-STAMP 2G, Dynaform, CAS, MS Visio...

Surface Treatment Laboratory (E424): Elcometer 456 thickness gauge, Mitutoyo SJ-301 digital portable roughness gauge with graphic recording, grid test set according to CSN EN ISO 2409, Elcometer 508 digital...

Metallography Laboratory (E427): It is used for the evaluation and documentation of pre-prepared samples of steels, cast irons, and non-ferrous metals. The actual evaluation of the samples is carried out using...

Welding and Forming Laboratory (L20): Heavy laboratory provides facilities for welding and cutting of materials, including the necessary preparation of semi-finished products. It houses a hydraulic press...

Laboratory of Unconventional Forming Methods (RF101): The research activity in this laboratory is focused on forming under conditions of multiple plastic deformation SPD (Severe Plastic Deformation). It houses...

Laboratory of Robotic Welding and Welding (L19): An ABB robot, an octagonal plasmanitrided table SW 600 x 50 for an ABB robot, and an IRBP 250A positioner for an ABB robot are located here. Research...

Welding Monitoring and Modelling Laboratory (L122 and N112): Used to monitor fusion and pressure welding technologies. The welding parameters, temperature, and voltage fields are monitored during...

Testing Laboratory (HA404): Micro-hardness tests are carried out using the LECO LM247AT automatic digital micro-hardness tester and the measurement of the material's resistance to abrasive surface wear using...

Metallography Sample Preparation Laboratory (E425): It is equipped with STRUERS instruments that are used to collect and prepare samples for metallographic testing. The automatic and manual cutting...